Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Hole's in Hull (for handles)
By:David Cain
Date: 2/1/1999, 7:49 am
Date: 2/1/1999, 7:49 am
Almost ready to paint the hull of a CLC 17, but I need to drill a hole (forward & aft) for carry handles. Question 1 is, do I drill now or after all the painting has occured, or sometime during. Question 2 is, do I need to insert some type of protective material (I recall a post, sometime ago, regarding the use of copper & plastic pipe) into the hole to give additional protection to the hull from chafing from the rope...+
David Cain
Messages In This Thread
- Hole's in Hull (for handles)
David Cain -- 2/1/1999, 7:49 am- Re: Hole's in Hull (for handles)
Paul Lund -- 2/2/1999, 3:58 am- Re: Hole's in Hull (for handles)
Preston Seu -- 2/2/1999, 12:16 am- 2nd vote for the pipe lining solution
Pete Ford -- 2/1/1999, 5:27 pm- Re: Hole's in Hull (for handles)
Lee -- 2/1/1999, 2:28 pm- Re: Hole's in Hull (for handles)
Nolan Penney -- 2/1/1999, 1:42 pm- Re: Hole's in Hull (for handles)
Jerry Weinraub -- 2/2/1999, 6:55 am- Re: Hole's in Hull (for handles)
Nolan Penney -- 2/3/1999, 1:47 pm- Basically
Brian T. Cunningham -- 2/3/1999, 3:01 pm
- Basically
- Re: Hole's in Hull (for handles)
- line the holes with copper pipe
Brian T. Cunningham -- 2/1/1999, 12:18 pm- Re: Hole's in Hull (for handles)
Jay Babina -- 2/1/1999, 10:15 am - Re: Hole's in Hull (for handles)
- Re: Hole's in Hull (for handles)
