Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Stapleless Stripping
By:Nick Schade - Guillemot Kayaks
Date: 3/9/1999, 2:48 pm
In Response To: Stapleless Stripping (Mac Buhler)

Another way to make this clamping form is to route a groove slightly back from the edge of the form. While this may not provide as secure a clamping point as the additional strip of form, it may be easier and quicker to produce.

> It is a pretty simple process. She cuts half-inch plywood about a
> half-inch thick to match the forms. This is glued to the forms to create a
> lip so that spring clamps can hold the strip in place while the glue
> dries. Be sure to put the strip on the side of form facing the center
> form.

Messages In This Thread

Stapleless Stripping
Mac Buhler -- 3/9/1999, 3:09 am
Re: Stapleless Stripping
eric schade (shearwater-boats) -- 3/25/1999, 3:02 pm
Stapleless Stripping book info?
Paul Jacobson -- 3/12/1999, 6:44 am
Re: Stapleless Stripping book info?
Bob Marr -- 3/12/1999, 8:00 am
Re: Stapleless Stripping
Nick Schade - Guillemot Kayaks -- 3/9/1999, 2:48 pm