4mm vs. 3mm decks
By:Shawn Baker
Date: 3/12/1999, 1:22 pm
Date: 3/12/1999, 1:22 pm
In Response To: Re: leave staples in? (Mike Scarborough)
I wonder why they use 4mm decks. I used doorskins for my deck, and I haven't had any problems. Seems like staying with a 3mm deck would give you some decent weight savings while not costing you all that much, structurally. (The deckbeams take up most of the structural job)
Shawn
> It takes more than a little force to hold the deck in position while the
> epoxy sets. I'd be careful of any solution that gives up holding power,
> especially now that, I think, CLC is using 4mm decks in some cases. (they
> used to use 3mm)
> Personally, I would use nails, not staples, but if I did use staples I'd
> be sure to use stainless ones.
Messages In This Thread
- leave staples in?
Dave -- 3/10/1999, 5:36 pm- Re: leave staples in?
Mike Scarborough -- 3/11/1999, 5:42 pm- 4mm vs. 3mm decks
Shawn Baker -- 3/12/1999, 1:22 pm- Re: 4mm vs. 3mm decks
Pete Rudie -- 3/12/1999, 2:48 pm- Re: 4mm vs. 3mm decks
John Lange -- 3/12/1999, 2:03 pm- Re: 4mm vs. 3mm decks
Shawn Baker -- 3/12/1999, 2:45 pm
- Re: 4mm vs. 3mm decks
- Re: 4mm vs. 3mm decks
- Re: leave staples in?
Shawn Baker -- 3/11/1999, 3:28 pm- STEEL ? paneling nails ??
Jamin -- 3/21/1999, 7:04 pm- Re: STEEL ? paneling nails ??
Shawn Baker -- 3/22/1999, 11:13 am
- Re: STEEL ? paneling nails ??
- Re: leave staples in?
Don Beale -- 3/11/1999, 12:37 pm- Re: leave staples in?
Nolan Penney -- 3/11/1999, 7:26 am- pull the staples
Paul Jacobson -- 3/10/1999, 10:46 pm- Re: leave staples in?
Jason Steeves -- 3/10/1999, 7:49 pm - 4mm vs. 3mm decks
- Re: leave staples in?