Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: fabricating a rudder
By:Gary Toffelmire
Date: 3/14/1999, 12:52 pm
In Response To: Re: fabricating a rudder (Rob Cochrane)

> Hi All

> I have plans for a rudder made from 4mm Aly plate and 16mm x 50mm Aly flat
> bar with two versions for both single and bouble. Only one problem. The
> design is for my range of Kayaks which have a vertical stern, so some
> modification may be needed to fit your particular kayak. Drawings are in
> AutoCAD .dwg file and can be E-mailed for snail mailed A4 size.

> Rob

I would like to see the dwg file could you post it or email it to me. Gary

Messages In This Thread

fabricating a rudder
Davy Riggs -- 3/14/1999, 3:21 am
Re: fabricating a rudder
Gary Toffelmire -- 3/14/1999, 12:50 pm
Re: fabricating a rudder - Nick's Plans?
Shawn Baker -- 3/15/1999, 12:52 am
Re: fabricating a rudder - Nick's Plans?
Gary Toffelmire -- 3/15/1999, 6:09 pm
Re: fabricating a rudder
Jerry Weinraub -- 3/14/1999, 11:33 am
Re: fabricating a rudder
Rob Cochrane -- 3/14/1999, 7:33 am
Re: fabricating a rudder
Gary Toffelmire -- 3/14/1999, 12:52 pm