Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Deck, Hull and Kevlar too
By:Andrew Nemeth
Date: 6/4/1999, 12:47 am
In Response To: Re: Deck, Hull and Kevlar too (Paul G. Jacobson)


> Of course you could try replacing the plane with a saw, too. If you are
> carefull you could get a perfect fit of deck and hull by splitting a strip
> lengthwise with your saw, and using one half to cap the hull srips, and
> the matching half as the starter strip for the deck.

Would you use a table saw to make this cut, or a razor saw after the strip was glued in place?

Messages In This Thread

Deck, Hull and Kevlar too
Andrew Nemeth -- 6/3/1999, 12:05 am
Re: Deck, Hull and Kevlar too
Nick Schade - Guillemot Kayaks -- 6/3/1999, 10:41 am
Re: Deck, Hull and Kevlar too
Paul G. Jacobson -- 6/3/1999, 1:08 am
Re: Deck, Hull and Kevlar too
Andrew Nemeth -- 6/4/1999, 12:47 am
Re: Deck & Hull cap strips
Paul G. Jacobson -- 6/5/1999, 10:10 pm