With the measurements provided, I layed out the hull outline of the bulkhead on the plywood. I then created a template (can be cardboard, stiff paper, scrape plywood, etc.) with the radius dimensions provided in the drawings (or wooden boat mag). Make sure each template is longer than the beam dimension of the bulkhead. Then, each template was layed on the corresponding hull outline and the top edge points of the shear line were connected. Hope this helps...

wd

> I have both issues of Woodenboat Magazine that has the plans to the Mill
> Creek 13 kayak. In the first issue they left out 6 measurements discribing
> the forward and aft bulkheads. They partially corrected this with 4 of the
> 6 measurements printed at the end of the article in the second issue.
> However, the total heights of both the fore and aft bulkheads were left
> out. If anyone knows what these two measurements are, I would appreciate
> the information.