You could make forms to go in betwixt by laying a small frame on the next closest larger frame (i.e. a bow frame on top of the next rearward frame, or a stern frame on the next foreward frame) and drawing a curve that splits the difference between the two. If there isn't any datum water line to line the frames up with, a bit of guessing would be involved. Lining up the shear points should work, though. Dean

> I have the forms left over from my Putz Walrus and I am thinking about
> using them to build a stripper. The main problem I see are that the forms
> are about two feet apart. Is this to far for 1/4" strips? I used
> 3/8" stringers in the skin version and they did not sag until the
> skin was pulled very tight. It should make a nice quick narrow hard chined
> boat.

> Mike