I got this idea after alot of thaught. I won't bother to tell you my previous ideas because they are all a bunch of @#$%. Well here go's

I want to mix stich & tape and strip building to make an 8 foot squirt boat that is primarily made for flat water. I will make a set of forms (1 every 12 inches) over these forms I would staple 6 inch wide peaces of 1/8 inche marine playwood. After the wood is all on I would put on a layer of 6 ounce fibreglass cloth. (just the regular unidirectional stuff) I would fibreglass the inside, outside and the top of the hull. My design is basicly like a white water play boat. but less volume. the ends would be flat not pointed and the bottom of the hull would be mostly flat. I have a design all drawn up but don't have a scanner.

If you notice anything wrong with this plan I would really appreciate a little advice from people with more expierience on the subjuct.

Thanks so much to everyone who helps out on this bbs

Dave