Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Bent shaft
By:Don Beale
Date: 10/23/1999, 11:19 am

I laminated a paddle shaft and it came out bent! I dont get it. I clamped it good all along, with a board on the top and a table on the bottom. The table is flat. I think I'll go buy two peices of 8' angle iron to make a jig. Any better ideas?

Messages In This Thread

Bent shaft
Don Beale -- 10/23/1999, 11:19 am
Re: Bent shaft
Bart Castleberry -- 10/23/1999, 10:25 pm
Re: Bent shaft
Randy Ames -- 10/23/1999, 1:41 pm
Sometimes you gotta....
Shawn Baker -- 10/26/1999, 11:58 am
Re: Bent shaft
Ed Valley -- 10/25/1999, 2:28 pm