> I am a new builder. I am beginning the stitching of the keel panels. The
> problem I am experiencing is that the sharp edges of the panels make it
> difficult to maintain alignment near the bow and stern. The sharp edges
> keep popping over each other as I pinch the panels together. It seems like
> the edges should be beveled where they meet in these areas but there is
> nothing in the instructions regarding that. Any suggestions would be
> appreciated.

Hi Wayne :)

Down below a few posts, there was a good list of ideas on bringing the shear clamps together with minimal gaps, and some would help here. A good one would be to bring the panels close together, with the stitching loose, say a 1/4 " or whatever will fit, and either run a file or paint stick with sandpaper between the two pieces to knock off the edges and give two mating surfaces at the same angle.

Rehd