Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip cutting adventures...
By:Jerry
Date: 2/10/2000, 1:07 am
In Response To: Re: Strip cutting adventures... (Simon)

In a marathon 11 hour day I (we) ripped and routed enough strips for four kayaks. I used the simple 1/4" B&C bits. B&C turned out fine. Make sure your routing set-up will hold the strips firmly. Check the strips from time to time as you mill them, to make sure your set has not changed. Learned this the hard way. Jerry

Messages In This Thread

Strip cutting adventures...
Hank -- 2/8/2000, 11:25 am
Re: Strip cutting adventures...
Walter H. Klaus -- 2/14/2000, 8:43 am
Re: Strip cutting adventures...
Simon -- 2/9/2000, 3:09 am
Re: Strip cutting adventures...
Jerry -- 2/10/2000, 1:07 am
Re: Strip cutting adventures...
Earl Bailey -- 2/9/2000, 3:55 pm
Re: Strip cutting adventures...
Paul Lund -- 2/9/2000, 9:18 am
Re: Strip cutting adventures...
Hank -- 2/9/2000, 8:12 am
Re: Strip cutting adventures...
Spidey -- 2/9/2000, 3:30 am
Re: Strip cutting adventures...
Spidey -- 2/8/2000, 11:00 pm
Re: Strip cutting adventures...
Earl Bailey -- 2/9/2000, 3:50 pm
Re: Strip cutting adventures...
Bill Light -- 2/8/2000, 5:35 pm
Re: Strip cutting adventures...
Hank -- 2/8/2000, 9:11 pm
Re: Strip cutting adventures...
Jim McCool -- 2/8/2000, 1:55 pm