Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

whoops
By:mike allen ---}
Date: 3/15/2000, 12:20 am
In Response To: Simple Scarfing (mike allen ---})

> Clamp them
> both together in this orientation 4in away from your table's (or some
> scrap) edge.

NOT from the table edge or you'll sand 4in into the table (duuuhhh).

You can also make a pencil mark 4 in away from the top pcs end and then you can get 3 things to line up when doing this. The mark, the intersection, and the lowest pt of the low strip. Just be careful not to wonk side to side.

-mick

Messages In This Thread

Scarfing the shear clamps
Brian T. Cunningham -- 3/14/2000, 3:10 pm
progress & 5 minute epoxy
Brian T. Cunningham -- 3/16/2000, 1:29 pm
oops
Brian T. Cunningham -- 3/16/2000, 1:44 pm
Re: Scarfing the shear clamps
Tony -- 3/15/2000, 5:19 pm
Simple Scarfing
mike allen ---} -- 3/15/2000, 12:06 am
whoops
mike allen ---} -- 3/15/2000, 12:20 am
Re: Scarfing the shear clamps
Paul G. Jacobson -- 3/14/2000, 10:21 pm
Re: Scarfing the shear clamps
Shawn Baker -- 3/14/2000, 3:38 pm
Need to get at least one good -- battens!!
Brian T. Cunningham -- 3/14/2000, 6:08 pm
Re: Need to get at least one good -- battens!!
Bill Jankowski -- 3/14/2000, 8:50 pm
Re: Scarfing the shear clamps
Hank -- 3/14/2000, 3:38 pm