Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Molding info source
By:Leonel
Date: 5/3/2000, 9:28 am
In Response To: Molding info source (Brian Nystrom)

I tryed
: Fiberglast (http://www.fiberglast.com)

but didnīt work... try http://www.fibreglast.com/

I am currently making a mould an planning to build a couple of kayaks for me and have some variabples to discuss refering layering fiberglass mat vs roving.

perhaps we can discuss some learning experiences.

I have used gelcoat, polyester anf Fiberglass and completed the two halves of the moulds wich i must reinforce further.

Messages In This Thread

can it be done?
David Blodgett -- 4/30/2000, 12:06 am
Epoxy vs. Polyester & Layups
mike -- 5/1/2000, 12:31 pm
Re: can it be done?
Bruce -- 4/30/2000, 7:07 pm
Re: Don't do it
lee -- 4/30/2000, 1:51 am
Re:Use Epoxy,
James Neely -- 4/30/2000, 6:41 am
Re:Use Epoxy, yah, right
David Blodgett -- 4/30/2000, 8:04 am
Re:Use Epoxy, yah, right
James Neely -- 4/30/2000, 8:50 pm
Re:Use Epoxy, yah, right
David Blodgett -- 4/30/2000, 9:16 pm
Re:Use Epoxy, yah, right
Charles Cooper -- 4/30/2000, 9:42 am
Danger Will Robinson, Danger
Mark -- 4/30/2000, 2:12 pm
Re:Use Epoxy, yah, right
John B. -- 4/30/2000, 11:14 am
Raka epoxy, perhaps?
Brian Nystrom -- 4/30/2000, 9:35 am
Re: less glass, perhaps?
David Blodgett -- 4/30/2000, 9:47 am
Re: less glass, perhaps?
Brian Nystrom -- 4/30/2000, 10:33 am
Re: less glass, perhaps?
David Blodgett -- 4/30/2000, 10:37 am
Molding info source
Brian Nystrom -- 5/1/2000, 6:48 am
Re: Molding info source
Leonel -- 5/3/2000, 9:28 am
Re: Molding info source
Bart Castleberry -- 5/3/2000, 9:32 pm
Re: less glass, perhaps?
Bart Castleberry -- 4/30/2000, 3:02 pm
Re: can it be done?
Terry Cockeram -- 4/30/2000, 12:40 am