Erez,

See response above. I have removed screws the way you describe, and the method works--for screws that are larger than this one. It is a #4 by 3/4", and the diameter of the piece that remains in the stem is about 1/16", if you don't count the threads. I'd have to be a dentist to drill and tap a hole in the center of it! Thanks for your thoughts, though.

Ken Sarkozy

: hello there,

: I didn't read all the responses, but here's what I know: drill a little hole
: in the broken piece left in yuor hull.

: make an opposite thread (ccw) in that little hole that is in the little
: broken piece.

: screw a screw into that hole & tighten it until it starts to turn the
: broken piece until the broken piece is out.

: yes, you need to get that tool that makes threads. it has to be with a
: diameter that is small enough, & it has to be a ccw thread. never saw
: one, never did it, it's just the way I was told broken screws are taken
: out.

: good luck,

: Erez