I reckon you've got a good point there, John. I just checked my 10 foot boards that I cut with support and they look good. My shorter boards are also fine. It's just my eight footers that I cut with no support that look a wee bit off. They'll go through again with my brand new board buddies. Thanks for the input.

Greg.

: Greg - I had the same trouble when I cut my bead and coves in 3/16"
: mahogany. I had a featherboard holding the strips down, and another
: holding them against the fence. The test cuts in short pieces of strips
: were dead on. When I cut the fourteen footers, however, the beads were
: slightly off center here and there. I traced the problem to the strips
: lifting off the table. This happened when the strips were left unsupported
: after running off the edge of the table. As the strip bent over the edge
: of the table, it sprung the part still on the table upward, causing an off
: center cut. This happened even though the feather board was adjusted to
: hold the strips down. I couldn't put enough pressure on the featherboard
: to stop the springing because then I couldn't move the strip. Next time I
: will have more featherboards and much longer infeed and outfeed support.
: Hope this sheds some light on your problem. - John