Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Craftsman Table Saw
By:Hank
Date: 6/30/2000, 1:32 pm
In Response To: Re: Craftsman Table Saw (Ken)

Hi Ken,

Like Don, I have had good luck with the Freud blades, buy them from Home Depot for about $14.00 Cndn.

I run the 7-1/2", 24 tooth, thin kerf blade Freud on my 10" Craftsman tablesaw [3/4 Hp]. It rips 2x4's very well - fast and smooth with little back-pressure.

The kerf is about .070 inch - compared to a bit over .125 for the standard 10" carbide blade that I buy from Canadian Tire.

Hank

Messages In This Thread

Craftsman Table Saw
Ken -- 6/29/2000, 9:52 pm
Re: Craftsman Table Saw
Tig and Tink -- 7/2/2000, 3:49 am
Get a thin kerf blade
Don Bowen -- 7/1/2000, 9:53 pm
Re: Craftsman Table Saw
Dan Lindberg -- 6/30/2000, 4:26 pm
Re: Craftsman Table Saw
Tony -- 7/6/2000, 4:23 pm
Re: Craftsman Table Saw
Frank Costanzo -- 7/11/2000, 8:19 pm
Re: Craftsman Table Saw
Frank -- 6/30/2000, 3:00 pm
Re: Craftsman Table Saw
Earl Bailey -- 6/30/2000, 2:16 pm
Re: Craftsman Table Saw
Allen -- 6/30/2000, 1:45 pm
Re: Craftsman Table Saw
Shawn B -- 6/30/2000, 10:59 am
Re: Craftsman Table Saw
Tig and Tink -- 7/2/2000, 4:06 am
Re: Craftsman Table Saw
Rehd -- 6/30/2000, 1:04 am
Re: Craftsman Table Saw
Ken -- 6/30/2000, 11:43 am
Re: Craftsman Table Saw
Rehd -- 6/30/2000, 7:59 pm
Re: Craftsman Table Saw
Hank -- 6/30/2000, 1:32 pm
Re: Craftsman Table Saw
Don Bowen -- 6/29/2000, 11:27 pm