Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Easiest way to cut strips?
By:Richard Boyle
Date: 8/7/2000, 10:30 pm
In Response To: Re: Easiest way to cut strips? (Tony)

Tony,

The blade was not tilted away from the fence. For some unknown reason it was removing more wood at the bottom of the cut than at the top. If I ran the board through without turning it over, the next strips still came out thicker at the top. If I flipped the board over between cuts, they came out fine, with the exception of the first strip.

Richard

Messages In This Thread

Easiest way to cut strips?
Stan Woronko -- 8/4/2000, 11:12 pm
Re: Easiest way to cut strips?
Richard Boyle -- 8/6/2000, 9:30 am
Re: Easiest way to cut strips?
Rehd -- 8/8/2000, 1:00 am
Re: Easiest way to cut strips?
Richard Boyle -- 8/8/2000, 6:42 pm
Re: Easiest way to cut strips?
Rehd -- 8/11/2000, 12:29 pm
Re: Easiest way to cut strips?
Rehd -- 8/9/2000, 12:58 am
Re: Easiest way to cut strips?
Tony -- 8/7/2000, 2:37 pm
Re: Easiest way to cut strips?
Richard Boyle -- 8/7/2000, 10:30 pm
Re: Easiest way to cut strips?
Rehd -- 8/8/2000, 12:45 am
Re: Easiest way to cut strips?
Dave Houser -- 8/6/2000, 10:23 am
Re: Easiest way to cut strips?
Rehd -- 8/5/2000, 2:22 am
Proud owner of half a mile of strips
Stan Woronko -- 8/9/2000, 1:18 pm
verbal picture of flat/vertical grain
Ed Valley -- 8/7/2000, 5:01 pm
Re: do you suppose...
Ross Leidy -- 8/7/2000, 5:08 pm
Re: Quarter-Sawn Lumber
Dave Houser -- 8/6/2000, 1:35 am
Re: Easiest way to cut strips?
Ronnie -- 8/5/2000, 4:06 pm
Thanks
Stan Woronko -- 8/5/2000, 1:28 pm