Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Vacuum bagging paddle blades
By:Shawn B
Date: 8/14/2000, 12:28 pm
In Response To: Re: Vacuum bagging paddle blades (david)

Hi David,

I plan to just slice off the end of the shaft. The blade will completely cover the void. The blades are curved and dihedral--I'll just plane the slice to match the slight curve of the near end of the curve.

I'll leave that lefty shaft with Joe.

Happy Paddling,

Shawn

: Shawn,

: How will you attatch the blades to the shaft? BTW, all is good with Joe to
: leave the leftty with him at R2K. Have fun out there!

: David

Messages In This Thread

Vacuum bagging paddle blades
Shawn Baker -- 8/14/2000, 12:05 am
Re: Vacuum bagging paddle blades
Darrell Pearse -- 8/17/2000, 12:02 pm
Re: Shop Vac pressure?
Shawn B -- 8/17/2000, 1:48 pm
Re: Different units
Don Beale -- 8/18/2000, 12:12 am
A question about vacuum
Brian Nystrom -- 8/18/2000, 10:39 am
Re: Different units
Shawn Baker -- 8/18/2000, 1:38 am
Making a vacuum bagging pump
Brian Nystrom -- 8/15/2000, 3:03 pm
here ya go *Pic*
Brian T. Cunningham -- 8/25/2000, 7:05 pm
Re: Vacuum bagging paddle blades
peter czerpak -- 8/15/2000, 8:14 am
Re: Vacuum bagging paddle blades
Shawn B -- 8/15/2000, 10:20 am
You probably all have seen this site but..
Tom Preska -- 8/15/2000, 11:50 am
Re: Won't burn up Shop Vac easily . . .
Spidey -- 8/14/2000, 10:52 pm
Re: Won't burn up Shop Vac easily . . .
Rehd -- 8/15/2000, 12:02 am
Re: Vacuum bagging paddle blades
david -- 8/14/2000, 12:20 pm
Re: Vacuum bagging paddle blades
Shawn B -- 8/14/2000, 12:28 pm
Re: Vacuum bagging paddle blades
peter czerpak -- 8/14/2000, 7:56 am