Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Won't burn up Shop Vac easily . . .
By:Rehd
Date: 8/15/2000, 12:02 am
In Response To: Re: Won't burn up Shop Vac easily . . . (Spidey)

: Hi Shawn;

: My glass layup buddy related a story to me some time ago about how they had
: just bagged some part of a pretty large sailboat hull under construction,
: and were ready to go home for the weekend. The vacuum pump died just as
: they were leaving, and they replaced it with a large Shop Vac (TM), (the
: real thing) and had no recourse other than to leave it for the night. He
: says it ended up running fine through Monday morning, 2-1/2 days later,
: apparently none the worse for wear! Plus, the vacuum bagging turned out
: fine.

: I think your 15 minute limit was a bit conservative . . . Sounds like
: something Dale might have cut off after perhaps 10 minutes, however . . .
: ;-)

: Trying to think of something to bag, Spidey

my ex-wife :)

Messages In This Thread

Vacuum bagging paddle blades
Shawn Baker -- 8/14/2000, 12:05 am
Re: Vacuum bagging paddle blades
Darrell Pearse -- 8/17/2000, 12:02 pm
Re: Shop Vac pressure?
Shawn B -- 8/17/2000, 1:48 pm
Re: Different units
Don Beale -- 8/18/2000, 12:12 am
A question about vacuum
Brian Nystrom -- 8/18/2000, 10:39 am
Re: Different units
Shawn Baker -- 8/18/2000, 1:38 am
Making a vacuum bagging pump
Brian Nystrom -- 8/15/2000, 3:03 pm
here ya go *Pic*
Brian T. Cunningham -- 8/25/2000, 7:05 pm
Re: Vacuum bagging paddle blades
peter czerpak -- 8/15/2000, 8:14 am
Re: Vacuum bagging paddle blades
Shawn B -- 8/15/2000, 10:20 am
You probably all have seen this site but..
Tom Preska -- 8/15/2000, 11:50 am
Re: Won't burn up Shop Vac easily . . .
Spidey -- 8/14/2000, 10:52 pm
Re: Won't burn up Shop Vac easily . . .
Rehd -- 8/15/2000, 12:02 am
Re: Vacuum bagging paddle blades
david -- 8/14/2000, 12:20 pm
Re: Vacuum bagging paddle blades
Shawn B -- 8/14/2000, 12:28 pm
Re: Vacuum bagging paddle blades
peter czerpak -- 8/14/2000, 7:56 am