Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: 1-part poly question for Ross
By:Joe Mellusi
Date: 8/31/2000, 2:30 pm
In Response To: Re: 1-part poly question for Ross (Ross Leidy)

: From what I remember, it looked really good, and I didn't notice any
: scratches (at least on the deck - I didn't see the hull). In all fairness,
: it was painted white, so even if there were some scratches through to the
: primer, they would have been difficult to find. I'll send some email to
: the builder and see if I can get some direct feedback.

: Ross

Ross and Dean

It is my kayak that Ross has mentioned in the postings. In use for 3 1/2 years and launched from Maine to Maryland. The finish has held up well. The hull has some scratches as well as the deck. I might add that I never did beach launchings, always paddle brace entries. The boat is white but most important the primer is off white. I did see the picture of the Cunningham kayak and it looks as if the primer is a different color. I would recommend a tinted or same prime color. It is easier to cope with the scrapes that way. All kayaks if "used" will show wear. Hope this helps. Joe

Messages In This Thread

1-part poly question for Ross
Dean Trexel -- 8/30/2000, 7:19 pm
Re: 1-part poly question for Ross
Ross Leidy -- 8/30/2000, 11:15 pm
Re: 1-part poly question for Ross
Joe Mellusi -- 8/31/2000, 2:30 pm
Re: 1-part poly question for Ross
Joe Mellusi -- 8/31/2000, 1:17 pm