Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: The Steering assembly
By:Kent LeBoutillier
Date: 9/11/2000, 2:05 pm
Date: 9/11/2000, 2:05 pm
In Response To: Re: The Steering assembly (mike allen --->)
Hi Mick,
The rudder post is made of nylon but, under the the round part visible in the pic is a piece of S.S. pipe about 1" long welded to it. The rudder post goes in the pipe and is pin in with a set screw. The pics were taken before I cut the rope off so now it's considerably smaller than you see.
Messages In This Thread
- Sneak Peek!! *Pic*
Kent LeBoutillier -- 9/10/2000, 8:17 pm- Re: Sneak Peek!!
Ricci -- 9/11/2000, 10:39 pm- Re: Sneak Peek!!
Ross Leidy -- 9/11/2000, 8:11 am- Re: Sneak Peek!!
Ed Walshe - Dublin -- 9/11/2000, 6:11 am- Drooling over the flames
Greg -- 9/10/2000, 10:37 pm- Re: Drooling over the flames
Kent LeBoutillier -- 9/11/2000, 6:01 am
- The Steering assembly *Pic*
Kent LeBoutillier -- 9/10/2000, 8:27 pm- Re: The Steering assembly
mike allen ---> -- 9/11/2000, 1:59 pm- Re: The Steering assembly
Kent LeBoutillier -- 9/11/2000, 2:05 pm
- Re: The Steering assembly
Mark -- 9/11/2000, 4:03 am- Re: The Steering assembly
Jack Martin -- 9/11/2000, 6:32 am
- Re: The Steering assembly
- The rudder *Pic*
Kent LeBoutillier -- 9/10/2000, 8:23 pm- try again *Pic*
Kent LeBoutillier -- 9/10/2000, 8:21 pm- peek 2 *Pic*
Kent LeBoutillier -- 9/10/2000, 8:18 pm - Re: Sneak Peek!!
- Re: Sneak Peek!!
