Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Steam bending with an iron?
By:Ken Sarkozy
Date: 10/4/2000, 8:42 pm

Some time ago there were a few references to one of this group's members using a steam iron to bend strips in place, i.e., without using a steam box. Can someone point me to where those posts are in the archives, or repost the one(s) describing the technique? T.I.A.,

Ken Sarkozy

Messages In This Thread

Steam bending with an iron?
Ken Sarkozy -- 10/4/2000, 8:42 pm
Re: Steam bending with an iron?
jason -- 10/6/2000, 11:32 am
Re: Steam bending with an iron?
Steve Lein -- 10/6/2000, 12:51 pm
Re: Steam bending with an iron?
Ken Sarkozy -- 10/6/2000, 12:48 pm
No, but I used a heat gun once
David Dick -- 10/5/2000, 7:00 am
Hey Kent, could you respond?
mike allen ---> -- 10/5/2000, 3:46 pm
Re: Hey Kent, could you respond?
Kent LeBoutillier -- 10/6/2000, 6:36 am
Re: Steam bending with an iron?
Ray Port Angeles -- 10/4/2000, 11:18 pm
Re: Steam bending with an iron? *Pic*
Shawn Baker -- 10/4/2000, 9:48 pm
Re: Steam bending with an iron? *Pic*
Mitch Isoe -- 10/4/2000, 9:02 pm
Re: Steam bending with an iron?
Dale Frolander -- 10/4/2000, 9:27 pm