Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Thin Kerf Blades
By:Steve L
Date: 10/12/2000, 9:46 pm
In Response To: Re: Thin Kerf Blades (John Michne)

Go with the 7 1/2" blades in the 10" saw. you do not need the depth of cut of the large blade. A cheap combination blade will give you an exceptable finish. The other big advantage of the smaller DIA. is that you are less likely to get blade wobble from a smaller thin blade. Cedar is easy stuff to rip but remember your dust mask and have fun, Steve

Messages In This Thread

Thin Kerf Blades
Steve -- 10/12/2000, 11:45 am
Re: Thin Kerf Blades
John Michne -- 10/12/2000, 12:37 pm
Re: Thin Kerf Blades
Steve -- 10/12/2000, 7:50 pm
Re: Thin Kerf Blades
John Michne -- 10/12/2000, 8:57 pm
Re: Thin Kerf Blades
bob -- 10/12/2000, 10:48 pm
Re: Thin Kerf Blades *Pic*
John Michne -- 10/13/2000, 7:26 am
Re: Thin Kerf Blades
Steve L -- 10/12/2000, 9:46 pm