Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Which Sander??
By:Kent LeBoutillier
Date: 10/23/2000, 6:06 am
In Response To: Re: Which Sander?? (Larry Pfisterer)

Hi Larry,
I have two different fairing boards, both are home made from plywood. One has a handle on each end and the other has a handle the full length. I made them long enough to take one piece of sand paper and cut it in half length wise and glue it to the board with spray on contact cement. If I remember it's 22" long. The one with the ridged back (handle length wise) is 2-1/2" wide, the other is about 3-1/2".

Messages In This Thread

Which Sander??
Doug Engel -- 10/20/2000, 4:24 am
Re: Anything but Ryobi
Richard Boyle -- 10/22/2000, 9:03 am
Re: Anything but Ryobi
Bruce -- 10/22/2000, 5:16 pm
Re: Which Sander??
Lee -- 10/20/2000, 11:32 pm
Get a DeWalt 421 hook-and-loop
Forrest -- 10/21/2000, 11:37 pm
Re: Get a DeWalt 421 hook-and-loop
Lee -- 10/22/2000, 9:51 am
RO, All the Way
Byron Lawrence -- 10/20/2000, 12:12 pm
Re: RO, varriable speed control
Steve L -- 10/20/2000, 8:16 pm
Re: Definitely ROS
Rehd -- 10/20/2000, 8:55 am
Re: Which Sander??
Matthew -- 10/20/2000, 8:53 am
Re: Which Sander??
Don Borntrager -- 10/20/2000, 8:38 am
Re: Which Sander??
Kent LeBoutillier -- 10/20/2000, 6:32 am
Re: Which Sander??
Larry Pfisterer -- 10/20/2000, 6:39 pm
Re: Which Sander??
Kent LeBoutillier -- 10/23/2000, 6:06 am
fairing board question
Chris Menard -- 10/23/2000, 11:19 am
Re: fairing board question
Kent LeBoutillier -- 10/23/2000, 11:38 am