That is an interesting idea, it might save some time in certain areas of the boat. I am hand beveling all of my strips for the Guillemot 17, and have found that the degree of bevel can vary dramatically from one end of the strip to the other. I bevel a short section and test fit it on the boat to see what the angle should be at the next form. It sounds pretty tedious but really goes faster than I expected. You may want to cut a small pile of several angles but leave most square until you try it out.

: Cutting strips? Has anyone cut batches of strips with on their table saw,
: with perhaps 2 degree edges, 4 degree edges, etc., so you can just reach
: for the appropaiate strip pile and have very little touch up for a fit?

: Thanks,
: John