Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Can We Discuss Carved Minicell Seats?
By:Larry C.
Date: 11/21/2000, 12:17 pm
In Response To: Re: Can We Discuss Carved Minicell Seats? (Ken Rasmussen)

: Larry has it right. You can make your foam seat really thin. I've gone as
: deep as 1/4" from the hull at the thinnest spots. I glue the seat in
: with contact cement. The foam will hold up fine, but you get a more
: professional look and a good nonskid surface if you cover it over with
: speaker grill cloth. The grill cloth needs to be applied with a spray
: adhesive. There is no need to make a fiberglass seat. You can get the foam
: seat in lower, it will last as long or longer, it is lighter, it is easier
: to make. When sanding foam that is not going to be covered with fabric use
: Dragonskin. Cut it into a strip 2.5" x 1", and cut the corners
: round. Used between the thumb and forefinger you can make finely finished
: surfaces that look like suede, and you can work inside of concavities.
: There is a web site I can refer you to that goes into all of this in
: detail, but I can't remember the address at this instant. Email me if you
: are interested. I will have found it by then. best wishes, Ken

Ken,
My knowledge of foam seat building came from your article in Sea Kayaker Magazine.

Larry C.

Messages In This Thread

Can We Discuss Carved Minicell Seats? *Pic*
Spidey -- 11/19/2000, 10:04 pm
Re: Can We Discuss Carved Minicell Seats?
Kathy Garlinghouse -- 11/21/2000, 1:20 am
Re: Can We Discuss Carved Minicell Seats?
Spidey -- 11/21/2000, 11:42 pm
Re: Can We Discuss Carved Minicell Seats?
Larry C. -- 11/20/2000, 10:07 pm
Re: Can We Discuss Carved Minicell Seats?
Spidey -- 11/20/2000, 10:29 pm
Re: Can We Discuss Carved Minicell Seats?
Ken Rasmussen -- 11/21/2000, 12:50 am
Re: Can We Discuss Carved Minicell Seats?
Larry C. -- 11/21/2000, 12:17 pm
Re: Ken's article
Shawn Baker -- 11/21/2000, 8:58 pm
Re: Seat Shape *Pic*
Shawn Baker -- 11/20/2000, 2:58 pm
Re: Shawn + Nick
Spidey -- 11/20/2000, 7:46 pm
Re: Sounds like you've got it.
Shawn Baker -- 11/21/2000, 11:16 am
Re: Sounds like you've got it.
Spidey -- 11/21/2000, 12:30 pm
Let's Try This Again :) S, N, & E
Spidey -- 11/20/2000, 8:06 pm
Re: Let's Try This Again :) S, N, & E
Nick Schade - Guillemot Kayaks -- 11/21/2000, 10:21 am
Re: Seat Dimensions *Pic*
Joe Greenley -- 11/20/2000, 9:20 pm
Re: Seat Dimensions
Spidey -- 11/20/2000, 9:49 pm
Re: Seat shape
Mike Hanks -- 11/20/2000, 8:43 pm
Re: Seat shape
Spidey -- 11/20/2000, 10:04 pm
Re: Seat shape
Richard Boyle -- 11/20/2000, 10:38 pm
Re: Seat shape
Spidey -- 11/20/2000, 11:04 pm
Re: Seat Shape
Nick Schade - Guillemot Kayaks -- 11/20/2000, 5:00 pm
Re: Seat Shape
eric schade (shearwater boats) -- 11/20/2000, 6:05 pm
Re: Wedge
Shawn Baker -- 11/20/2000, 5:56 pm
Me too!
Kent LeBoutillier -- 11/21/2000, 6:20 am
You can cover it in lycra.
.tim -- 11/20/2000, 1:01 pm
Re: You can cover it in lycra.
Spidey -- 11/20/2000, 8:13 pm
Burn it! ; )
Jerry Siegel -- 11/20/2000, 11:28 am
Re: I Did! :)
Spidey -- 11/20/2000, 1:40 pm
Can you sand it and coat again?
Brian Nystrom -- 11/21/2000, 12:45 pm
Re: Can you sand it and coat again?
Spidey -- 11/21/2000, 12:57 pm
Re: Can you sand it and coat again?
Jim Goecks -- 11/21/2000, 1:45 pm
Re: Burn it! ; )
Spidey -- 11/20/2000, 12:09 pm
Re: Can We Discuss Carved Minicell Seats?
Chris Casazza -- 11/20/2000, 11:19 am
Re: Can We Discuss Carved Minicell Seats?
Spidey -- 11/20/2000, 12:00 pm
Another thought on fiberglass lay-up
Jim Eisenmenger -- 11/20/2000, 4:51 pm
Re: Another thought on fiberglass lay-up
Spidey -- 11/20/2000, 10:14 pm
Re: Another thought on fiberglass lay-up
peter czerpak -- 11/21/2000, 8:28 am
Re: Another thought on fiberglass lay-up
Jim Eisenmenger -- 11/21/2000, 8:03 am
Re: Can We Discuss Carved Minicell Seats?
Chris Casazza -- 11/20/2000, 12:08 pm
Re: spray-on rubber coating
Dave E -- 11/20/2000, 10:22 am
Re: spray-on rubber coating
Spidey -- 11/20/2000, 11:46 am
Re: Can We Discuss Carved Minicell Seats?
Gini L. -- 11/19/2000, 11:44 pm
Re: Can We Discuss Carved Minicell Seats?
Spidey -- 11/20/2000, 12:09 am
Re: Can We Discuss Carved Minicell Seats?
Nick Schade - Guillemot Kayaks -- 11/20/2000, 9:39 am
Re: Can We Discuss Carved Minicell Seats?
Gini L. -- 11/20/2000, 10:58 pm
Re: Can We Discuss Carved Minicell Seats?
Spidey -- 11/20/2000, 1:32 pm
Vinyl?
Tom Tieman -- 11/20/2000, 6:24 pm
Re: Can We Discuss Carved Minicell Seats?
Grant Glazer -- 11/20/2000, 12:32 pm
Re: Can We Discuss Carved Minicell Seats?
John Monfoe -- 11/20/2000, 4:24 am
Re: Buoyancy
Shawn Baker -- 11/20/2000, 3:07 pm