Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Scaling Down S&G Plans
By:Ray
Date: 1/4/2001, 8:05 am
In Response To: Re: Scaling Down S&G Plans (John ,Montreal)

John, your post is encouraging. I too am trying to modify the plans for a boat for my wife. When you say you reduced the width of the side panels by 1/2 inch, was that a uniform 1/2 inch across the entire top of the panel length? Also did you make any width modifications to the bottom panels? If you didn't, I am assuming that the max beam is the same as your CH17. Thanks.

Ray

Messages In This Thread

Scaling Down S&G Plans
Ray -- 1/3/2001, 2:13 pm
Re: Scaling Down S&G Plans
John ,Montreal -- 1/3/2001, 10:57 pm
Re: Scaling Down S&G Plans
Ray -- 1/4/2001, 8:05 am
Re: Scaling Down S&G Plans
John ,Montreal -- 1/4/2001, 12:06 pm
Re: Scaling Down S&G Plans
Ray -- 1/4/2001, 12:33 pm
Re: Scaling Down S&G Plans
Eric Schade (shearwater boats) -- 1/3/2001, 7:01 pm
Re: Scaling Down S&G Plans
Ray -- 1/4/2001, 8:22 am
Re: Scaling Down S&G Plans
Eric Schade (shearwater boats) -- 1/4/2001, 8:49 am
Thanks for the info *NM*
Ray -- 1/4/2001, 12:35 pm
Re: Scaling Down S&G Plans
Tony B. -- 1/3/2001, 5:08 pm
Re: Scaling Down S&G Plans
Jim Eisenmenger -- 1/3/2001, 3:08 pm