Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: TS Blade for ripping strips?
By:Steve L
Date: 1/30/2001, 5:43 pm
In Response To: Re: TS Blade for ripping strips? *NM* (Steve L)

If you are not ripping miles of stock you could avoid the spacer set up and simply rip em out one at a time all by yourself. The key is get a 7 1/4 IN. thin kerf blade. A cheap one will do just fine (your going to sand the whole thing anyway). It really doesn't take very long to rip the stock and it is safest doing them one at a time. Happy ripping, Steve

Messages In This Thread

TS Blade for ripping strips?
Doug Miller -- 1/30/2001, 12:07 am
Re: TS Blade for ripping strips?
Lance Alldrin -- 1/30/2001, 4:56 pm
Re: TS Blade for ripping strips? *NM*
Steve L -- 1/30/2001, 5:37 pm
Re: TS Blade for ripping strips?
Steve L -- 1/30/2001, 5:43 pm
Re: TS Blade for ripping strips?
Don B. -- 1/30/2001, 1:16 pm
Re: TS Blade for ripping strips?
daren -- 1/30/2001, 12:33 am