Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

spraying
By:Don Flowers
Date: 1/30/2001, 11:11 pm
In Response To: Re: Sanding between Varnish Coats (daren)

: hi don;
: got a question for you regarding spraying varnish.
: i've been told it is not advisable because of there being a higher risk of
: explosion than with paint.
: also, i've been told that the fumes are very toxic. the guy actually said
: "deadly".
: i'd really like to hear some other opinions on this, so lets open the can and
: loose the worms!!
: regards;
: daren.....
We treated it as deadly -- lots of ventilation and respirators with fresh cartridges . Doubt if it is as toxic as what they are painting cars with now. Also treated it has highly explosive -- everything was out of the shop, no fire in the wood stove, no smoking, compressors outside (I have to hook three together to have the volume and storage to keep the pressure even). As it was, we probably lost a few brain cells but that's just culling the ones I haven't used for a few years or that I damaged in the 60's. However, it was three boats done in one day with no further work. Boats were hung horizantally from wires through the grab holes and the fellow was able to spray top bottom and sides at one go. His technique was to lay on a very light coat, let it get a bit tacky then load it up, let it set up and then repeat. (not sure what that all means 'cause I'm not a painter but it's what he said and he did it with only one tiny run in four full coats. Next time, I'm looking at setting up a temporary paint booth.
good luck and be careful
don

Messages In This Thread

Sanding between Varnish Coats
Todd Fry -- 1/28/2001, 9:23 pm
Re: Sanding between Varnish Coats
Don Flowers -- 1/30/2001, 8:25 pm
Re: Sanding between Varnish Coats
daren -- 1/30/2001, 9:06 pm
Re: VOC's
Ian Johnston -- 1/31/2001, 3:24 am
spraying
Don Flowers -- 1/30/2001, 11:11 pm
Satin Varnish
Pete Rudie -- 1/29/2001, 11:42 pm
Re: Sanding between Varnish Coats
Nick Schade - Guillemot Kayaks -- 1/29/2001, 1:22 pm
Re: Sanding between Varnish Coats
Rob Macks -- 1/29/2001, 10:13 am