: Looks great!
Thanks!

Be sure to seal the joint at the meeting of the upper and lower
: bow thoroughly. In the past I've had problems with water intrusion here
: because I made the cut between the upper and lower bow pieces too small to
: get in there to examine the joint. Now I like to be able to run a file
: through there so I can get at the joint to make sure it's sealed properly.

I opened that area up a little before glassing as I couldn't get in there either. What should I use, Thickened epoxy or push some glass into the joint.
I was thinking it would be easier to get in there when I turn the hull over so I don't have to stand on my head to work there.
Steve