: This is the drawing of a Kayak Yoke that Ken from Canada sent me. I am just
: now able to get it posted because I couldn't get my scanner files to
: convert to a readable picture. My sister told me to open it in MS-Paint
: Brush and it works.

: I croped some of the drawing off but not much. The 3/4" x 3/4" x
: 2" pieces are wood and slip up under the coaming lip and tighten in
: place.

: John

Good find John !

If you positioned the the shoulder blocks properly and it was cut to fit your
kayak width you could almost add an axle recepticle on each side , a few straps and some extra padding and it could probably pull double duty as a kayak cart
as the shoulder blocks will pivot to fit the bottom of your boat...hmmm Maybe.
Where is Mick!!.. here boy .. come and get it!!!

Later
Bill