Cutting strips, setting up table saw
By:Andy Hastings
Date: 4/2/2001, 9:40 am
Date: 4/2/2001, 9:40 am
When you cut your strips how do you set up your table saw? I am using S3S lumber. Is it safe to set the tablesaw fence at 1/4 inch and cut all the strips the same, or should I move the fence after every cut?
Thanx,
Andy Hastings
Messages In This Thread
- Cutting strips, setting up table saw
Andy Hastings -- 4/2/2001, 9:40 am- Re: Cutting strips, setting up table saw
Charlie Lesh -- 4/3/2001, 3:41 pm- Re: Cutting strips, setting up table saw
Bob -- 4/2/2001, 10:38 pm- Re: Cutting strips, setting up table saw
Rob Macks -- 4/3/2001, 4:30 pm- Re: Cutting strips, setting up table saw
MikeWhy -- 4/3/2001, 11:08 pm- Re: Cutting strips, setting up table saw
Geo. Cushing -- 4/4/2001, 4:31 pm- Re: Cutting strips, setting up table saw
Ronnie -- 4/4/2001, 3:12 pm- Re: Cutting strips, setting up table saw *Pic*
Rob Macks -- 4/4/2001, 9:49 am - Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw
Ronnie -- 4/2/2001, 2:33 pm- Re: Cutting strips, setting up table saw
Nick Schade - Guillemot Kayaks -- 4/2/2001, 9:59 am- Re: Cutting strips, long fence
Grant Goltz -- 4/4/2001, 2:01 pm- extremely short fence
Paul G. Jacobson -- 4/4/2001, 9:16 pm
- Re: Cutting strips, setting up table saw
Andy Hastings -- 4/2/2001, 10:01 am- Re: Cutting strips, setting up table saw
Rehd -- 4/2/2001, 8:16 pm- Re: Skinny push stick
Steve L -- 4/2/2001, 1:12 pm - Re: Skinny push stick
- extremely short fence
- Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw