Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Cutting strips, setting up table saw
By:Ronnie
Date: 4/2/2001, 2:33 pm
In Response To: Cutting strips, setting up table saw (Andy Hastings)

Andy,

Make sure that your table saw is tuned up. Blade and rip fence parallel. The extended fence is a good idea. Have support going in and comming out, rememembering that the strips will sag a lot, it is better to use a solid support comming out of the saw.(not rollers)

Messages In This Thread

Cutting strips, setting up table saw
Andy Hastings -- 4/2/2001, 9:40 am
Re: Cutting strips, setting up table saw
Charlie Lesh -- 4/3/2001, 3:41 pm
Re: Cutting strips, setting up table saw
Bob -- 4/2/2001, 10:38 pm
Re: Cutting strips, setting up table saw
Rob Macks -- 4/3/2001, 4:30 pm
Re: Cutting strips, setting up table saw
MikeWhy -- 4/3/2001, 11:08 pm
Re: Cutting strips, setting up table saw
Geo. Cushing -- 4/4/2001, 4:31 pm
Re: Cutting strips, setting up table saw
Ronnie -- 4/4/2001, 3:12 pm
Re: Cutting strips, setting up table saw *Pic*
Rob Macks -- 4/4/2001, 9:49 am
Re: Cutting strips, setting up table saw
Ronnie -- 4/2/2001, 2:33 pm
Re: Cutting strips, setting up table saw
Nick Schade - Guillemot Kayaks -- 4/2/2001, 9:59 am
Re: Cutting strips, long fence
Grant Goltz -- 4/4/2001, 2:01 pm
extremely short fence
Paul G. Jacobson -- 4/4/2001, 9:16 pm
Re: Cutting strips, setting up table saw
Andy Hastings -- 4/2/2001, 10:01 am
Re: Cutting strips, setting up table saw
Rehd -- 4/2/2001, 8:16 pm
Re: Skinny push stick
Steve L -- 4/2/2001, 1:12 pm