Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Cutting strips, setting up table saw
In Response To: Cutting strips, setting up table saw (Andy Hastings)
Andy:
In addition to the above good advice...you might want to check out the archives...there are an awful lot of postings about this issue....have found them real helpful....am about ready to cut strips for the first time too!
Make sure to save sawdust for patching/filling...
Enjoy...bob
Messages In This Thread
- Cutting strips, setting up table saw
Andy Hastings -- 4/2/2001, 9:40 am- Re: Cutting strips, setting up table saw
Charlie Lesh -- 4/3/2001, 3:41 pm- Re: Cutting strips, setting up table saw
Bob -- 4/2/2001, 10:38 pm- Re: Cutting strips, setting up table saw
Rob Macks -- 4/3/2001, 4:30 pm- Re: Cutting strips, setting up table saw
MikeWhy -- 4/3/2001, 11:08 pm- Re: Cutting strips, setting up table saw
Geo. Cushing -- 4/4/2001, 4:31 pm- Re: Cutting strips, setting up table saw
Ronnie -- 4/4/2001, 3:12 pm- Re: Cutting strips, setting up table saw *Pic*
Rob Macks -- 4/4/2001, 9:49 am - Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw
Ronnie -- 4/2/2001, 2:33 pm- Re: Cutting strips, setting up table saw
Nick Schade - Guillemot Kayaks -- 4/2/2001, 9:59 am- Re: Cutting strips, long fence
Grant Goltz -- 4/4/2001, 2:01 pm- extremely short fence
Paul G. Jacobson -- 4/4/2001, 9:16 pm
- Re: Cutting strips, setting up table saw
Andy Hastings -- 4/2/2001, 10:01 am- Re: Cutting strips, setting up table saw
Rehd -- 4/2/2001, 8:16 pm- Re: Skinny push stick
Steve L -- 4/2/2001, 1:12 pm - Re: Skinny push stick
- extremely short fence
- Re: Cutting strips, setting up table saw
- Re: Cutting strips, setting up table saw
