: Hi Simone

: This step alone could be cut down to an hour or two with the board
: straightener I have used for many years. It takes about 30 minutes to
: construct if you have all the materials at hand. When set on the saw, you
: can run the boards through it twice ( on most boards ) and have your
: square edge, ready to use on the table saw. In 30 minutes, you could have
: more lumber run than you need for two or three boats.

: Having the long infeed and outfeed tables is a very important step. It makes
: any saw process much simpler and quicker. On the ripping combo, I don't
: think I would try using more than a two blade gang set up. It just doesn't
: sound safe to me. Too many cutting edges to worry about at one time. ???

: The power feeders I've seen run anywhere from $300 to around $600 or more.
: Easily the cost of building one or two boats.

: Rehd

Hi Rehd,

I've seen your board straightener in a previous link, and was quite intrigued. I was considering buying a jointer this year, but I will try out your straightener first.

Thanks

Simon