: The spots with exposed glass will absorb the varnish differently but after a
: couple coats should look fine. If you want to be meticulous you could
: apply resin to the spots and resand.

: Getting rid of dust is the only way to ensure a good smooth varnish finish. I
: always use a tack cloth, wiped LIGHTLY over the surface prior to each coat
: of varnish.

: I use 220 wet/dry paper to sand before and between coats of varnish. Water
: used in wet sanding lubricates and removes particals from the paper making
: it very efficent. I wrap the paper around a closed cell foam block to
: conform to the curved surfaces. Wet sanding is also nice because you don't
: have to wear a dust mask. You must wash off the sanding residue with clean
: water and a sponge, then dry with paper towels, NOT a rag which might
: leave lint.

: All the best,

: Rob Macks
: Laughing Loon CC&K
: www.LaughingLoon.com

Thanks Rob for the info, you have always been a great help. Your posts to us first timers shows your genuine interest in helping us finish a project that sometimes feels a little overwhelming. And that you are not just posting to show your abilities, but to help others,,Thanks for your concern.
p.s. by the way, those flush hatches with the magnets seem to work really well.
we'll see after the boat gets on the water. I'll have to find a way to put some pictures on here because it is about ready to float and I'm mighty proud. (can't believe that came out of my garage)
Ron