Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: carving in a hard chine on a stripper
By:Rick Mitchell
Date: 6/25/2001, 8:54 pm
Date: 6/25/2001, 8:54 pm
In Response To: carving in a hard chine on a stripper (!RUSS)
: AFter building the hull I steamed the hard
: chne strisp and left them drying in a nailed jig. Flat piece of wiood with
: nails every inch on hte curve. Then I sanded in the chine. Hope yours
: works well
: !RUSS
Rounding the edges of the forms slightly and using no nails or steam seems to work well also.
Rick
Messages In This Thread
- Progress Report
Rick Mitchell -- 6/22/2001, 9:40 pm- carving in a hard chine on a stripper
!RUSS -- 6/24/2001, 10:23 pm- Re: carving in a hard chine on a stripper
Rick Mitchell -- 6/25/2001, 8:54 pm
- Re: Progress Report
daren neufeld -- 6/23/2001, 12:42 am - Re: carving in a hard chine on a stripper
- carving in a hard chine on a stripper
