Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Gutter less car rack holder designed by Gorden
By:Bill Boyd
Date: 7/21/2001, 1:20 am

: I plan on running two 1 1/8" outside dia. round conduit pipes across
: the car and into the oak side rails. On that will fit 4 Yakima Kayak
: Saddles I got off of E-bay.
: John
: Have you considered 3/4" black pipe used for bar clamps/gas lines. I
: think it would be stronger then conduit piping. There is considerable
: loads placed on roof rack bars at highway speeds and I have even managed
: to bend Yakima's bars when pushing therewieght limit of 100 Lbs per cross
: bar. Just a thought.
: Cheers
: Rick

Hi Rick
1" black poly pipe fits nicely over the outside of that 3/4" pipe as well.. giving it a corrosion resistant finish.
I was going to update my ash roof rack like that and using short lengths of
1 1/8" poly tubing to slide over those cross bars for my sliding ,side loading yak cradles ...but still gathering hardware.

later
Bill

Messages In This Thread

Gutter less car rack holder designed by Gorden *Pic*
John Monfoe -- 7/20/2001, 5:38 am
Re: Gutter less car rack holder designed by Gorden
rick M -- 7/20/2001, 9:00 pm
Re: Gutter less car rack holder designed by Gorden
John Monfoe -- 7/21/2001, 7:00 am
Re: Gutter less car rack holder designed by Gorden
Bill Boyd -- 7/21/2001, 1:20 am
Re: Gutter less car rack holder designed by Gorden
John Monfoe -- 7/21/2001, 6:37 am
Re: Gutter less car rack holder designed by Gorden
Bill Boyd -- 7/21/2001, 10:19 am
Re: Should work well
Shawn Baker -- 7/20/2001, 10:46 am
Re: Should work well
John Monfoe -- 7/21/2001, 6:52 am
That's great!
Tony B -- 7/20/2001, 8:41 am