Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Canoe Stripper plans
By:Jim
Date: 7/30/2001, 2:07 pm
In Response To: Canoe Stripper plans (Brian)

Brian

I have a 16 ftr, see link below. Plans were very reasonable. It's a little tricky if you are building your first stripper because of the big tumblehome but that will be true of any solo you would want to build. Plans are for almost a dead straight keel line. I put abt a half inch rocker in the bow. It tracks very straight. I think I would try 1.5 in the bow and 0.5 in stern if I was building it again to give it a little more nimbleness. If you want a workout boat for big water leave it alone. I have had it out in 3 ft whitecaps with abt 30 k wind and it took no water but I had to stay on my toes. As long as you have some forward motion this one will track. 17 ft is a very big solo, unless you have tons of gear might be too big to be fun.

Messages In This Thread

Canoe Stripper plans
Brian -- 7/30/2001, 1:53 pm
Re: Canoe Stripper plans
Arnie -- 8/5/2001, 3:52 am
Get Hazen's or Gilpatrick's books
Paul G. Jacobson -- 7/31/2001, 3:55 am
Re: Pulling shear in
Jim -- 7/31/2001, 5:47 pm
Re: Canoe Stripper plans *Pic*
Chip Sandresky -- 7/30/2001, 6:40 pm
Re: Canoe Stripper plans *Pic*
Ross Leidy -- 7/30/2001, 4:48 pm
Re: Canoe Stripper plans
Jim -- 7/30/2001, 2:07 pm
38 Special *Pic*
Jason -- 7/30/2001, 9:12 pm
Re: 38 Special
Jim -- 7/31/2001, 5:30 pm
Re: 38 Special
Jason -- 7/31/2001, 7:12 pm
Re: Al G
Jim -- 8/1/2001, 11:08 am
Sabot
Jason -- 8/1/2001, 6:40 pm
Re: Sabot
Jim -- 8/2/2001, 2:18 pm
Re: 38 Special
Jim -- 8/1/2001, 10:44 am