Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: But I cheat by
By:Don Beale
Date: 8/1/2001, 5:18 pm
In Response To: Re: Paddle shaft sanding block (Rob Macks)

Cutting the shaft square to it's overall dimension, about 1-1/4 x 1, and using a 3/4" roundover bit on the router table. It comes out nice and uniform, and is even faster than the drill press. Keep those fingers away from the bit!

Messages In This Thread

Paddle shaft sanding block *Pic*
Pete Rudie -- 7/31/2001, 5:42 pm
Re: Paddle shaft sanding block
Rob Macks -- 8/1/2001, 9:46 am
Re: Paddle shaft sanding block
Pete Rudie -- 8/1/2001, 11:17 pm
Re: But I cheat by
Don Beale -- 8/1/2001, 5:18 pm
Re: You can do the same thing
Don Beale -- 8/1/2001, 5:16 pm
Re: Paddle shaft sanding block
Rehd -- 8/1/2001, 10:47 am
Re: Paddle shaft sanding block
Rob Macks -- 8/1/2001, 2:14 pm