Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Beveling Tern deck recess
By:Mike
Date: 8/3/2001, 12:14 pm
In Response To: Re: Beveling Tern deck recess (Jim Kozel)

: The triangular deck recess panel gets beveled on the two sides that will rest
: against the rear deck panels. Same idea as beveling the shear panel edges.
: The bevel allows the piece to glue against the deck panels with a closed
: seam. My Stanley block plane made short work of that. On the Pygmy boats,
: some of the seams are "open" and get filled with thickened
: epoxy. Others are "closed" for a clean seam i.e. the shear seam.
: I'll take a pic and post it on my Tern Project site over the next couple
: of days.

wicked..thanks a ton..I am continually learning a ton from this forum

Messages In This Thread

Ron Folland
Mike Dangelo -- 7/31/2001, 5:12 pm
Re: Ron Folland
Jim Kozel -- 8/1/2001, 10:34 am
recessed rear deck
Mike Dangelo -- 8/1/2001, 10:46 am
Re: recessed rear deck
Keith Marsh -- 8/2/2001, 10:42 am
Re: recessed rear deck
Jim Kozel -- 8/2/2001, 11:53 am
Re: recessed rear deck
Keith Marsh -- 8/2/2001, 12:39 pm
Re: recessed rear deck Pygmy Arctic Tern 17'
Jim Kozel -- 8/2/2001, 3:58 pm
Re: AT general impressions
Jim Kozel -- 8/2/2001, 2:23 pm
Re: AT general impressions
Keith Marsh -- 8/2/2001, 4:47 pm
Stitching Tern deck recess
Jim Kozel -- 8/3/2001, 12:09 am
Re: Stitching Tern deck recess
Mike -- 8/3/2001, 8:37 am
Re: Beveling Tern deck recess
Jim Kozel -- 8/3/2001, 10:12 am
Re: Beveling Tern deck recess
Mike -- 8/3/2001, 12:14 pm
Re: hatches/end pour & recessed rear deck
Jim Kozel -- 8/1/2001, 11:43 am
Re: hatches/end pour & recessed rear deck
Nathan -- 8/1/2001, 1:06 pm
Re: Arctic Tern recessed rear deck
Jim Kozel -- 8/1/2001, 2:36 pm
Re: hatches/end pour & recessed rear deck
Mike Dangelo -- 8/1/2001, 1:53 pm
Re: hatches/end pour & recessed rear deck
Nathan -- 8/2/2001, 10:18 am
hatches and end pour
Mike Dangelo -- 8/1/2001, 10:44 am
Re: Roy Folland
Matthew Bastian -- 8/1/2001, 8:14 am
Built it
!RUSS -- 7/31/2001, 10:17 pm
Re: Built it
Mike Dangelo -- 8/1/2001, 10:32 am
Re: Ron Folland
Don Beale -- 7/31/2001, 6:46 pm
Re: Ron Folland
Doug in E Ont -- 7/31/2001, 8:03 pm
Re: Ron Folland
Mike Dangelo -- 7/31/2001, 6:40 pm