Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Thin kerf blade wobble
By:Ric Altfather
Date: 8/10/2001, 2:04 pm
In Response To: Re: Thin kerf blade wobble (daren neufeld)

: hi pete;
: i use a 7 1/4" hollow ground planer on my 10" table saw. this seems
: to be easier on the saw, and eliminates wobble (due to the smaller
: diameter).
: daren.....

You can also add stabilizers with the 7 1/4" thin kerf blades which make for a smooth cut, no vibration, minimal saw dust and as Daren states, real easy on the saw. The Matsushita 7 1/4" blades ($26) are the best.

Ric

Messages In This Thread

Cutting Strips
Jim Martin -- 8/9/2001, 10:04 am
Re: Cutting Strips
scott e. davis -- 8/9/2001, 1:25 pm
Re: Cutting Strips
Jim Kozel -- 8/9/2001, 2:35 pm
Re: Cutting Strips
scott e. davis -- 8/10/2001, 1:34 pm
Re: Cutting Strips
Rehd -- 8/9/2001, 3:46 pm
Thin kerf blade wobble
Pete Roszyk -- 8/9/2001, 7:35 pm
Re: Thin kerf blade wobble
daren neufeld -- 8/9/2001, 8:27 pm
Re: Thin kerf blade wobble
Ric Altfather -- 8/10/2001, 2:04 pm
Veritas Saw Blade Truing Disk
Kenny Too Slow -- 8/10/2001, 7:12 pm
Cutting for uniformity
!RUSS -- 8/9/2001, 12:53 pm
Re: Cutting Strips
Brian McM -- 8/9/2001, 11:53 am
Re: Cutting Strips
mark stevens -- 8/12/2001, 4:51 pm
Re: Cutting Strips
Rehd -- 8/9/2001, 11:41 am
Re: Cutting Strips
Stan Woronko -- 8/9/2001, 11:19 am