Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Have you done it?
By:Mark Kanzler
Date: 7/1/1998, 12:22 am
In Response To: Re: Have you done it (Duane Strosaker)

Done similar stuff. You staem bend 1/8" material into a hoop, then bend more 1/8" material into a hoop 1/8" larger all the wat arround (1/4" bigger dia. hoop), then pin them down on a board (like model airplanes) in correct shape glued (laminated) together.

> About your advice on laminating frames
> have you done it? That advice sounds funky to me,
> and I can't believe you are talking from experience.

Messages In This Thread

Frame Bending Lesson
Duane Strosaker -- 6/28/1998, 12:27 pm
Re: Frame Bending - Springback formula
Dave Greenway -- 7/1/1998, 2:23 pm
Re: Frame Bending - Springback formula
Bram van der Sluys -- 7/4/1998, 5:40 pm
Re: Frame Bending - Springback formula
Mark Kanzler -- 7/1/1998, 4:30 pm
Re: Frame Bending - Springback formula
Mike Spence -- 7/1/1998, 4:57 pm
Re: Frame Bending Tragedy
Mark Kanzler -- 6/29/1998, 3:55 pm
Re: Have you done it
Duane Strosaker -- 6/30/1998, 12:41 pm
Re: Have you done it?
Mark Kanzler -- 7/1/1998, 12:22 am
Been there, done it a bit
Paul Jacobson -- 6/30/1998, 1:25 am
Re: Been there, done it a bit
Paul Jacobson -- 6/30/1998, 2:07 am
Re: Been there, done it a bit
David Dick -- 6/30/1998, 9:59 am
Re: Tragedy
Roger Tulk -- 6/29/1998, 9:56 pm
Re: Frame Bending Lesson
Roger Tulk -- 6/29/1998, 9:38 am