: I have begun varnishing my project, but I am having problems. I am using
: Epifanes varnish and I'm getting tiny bubbles all over the place. (it is
: the type advertised as no sanding between coats required) It seems to
: occur as soon as I apply the varnish to the boat. I have tried both china
: bristle brush and two types of foam brushes, all with the same results. My
: Guillemot has West System Epoxy, and it has been well cured and sanded
: with 100 grit. I then washed the hull with paint thinner and let dry for a
: day. Weather here on Bainbridge Island (near Seattle) is a bit cool at
: night, temps into the high 50's, moderate humidity, but no rain (thank
: goodness).

: I could sure use a bit of advice on this. Any suggestions?

I've not used the foam for varnishes, so can't comment on them, but the China Bristle brush should be fine. Are you applying the varnish in " One Direction Only?" Always had the best luck keeping the brush well " wet " and move only one way. No back and forth, and No cross strokes. It takes a light touch as well. Don't force the brush as with paint. Varnish is funny stuff and take a little practice. And even if they say you don't have to sand between coats, it's not going to hurt to lightly " Wet-sand " a couple of coats, and then do the Great Job on the last coat or two. If you've never used Varnish before, Not to Worry, I've seen Very Few folks get their first or first few coats perfect. Did I say that Varnish is funny stuff???

Don't fret much, just let it dry, wet sand it and go at it again. Give it till the 3rd or 4th coat to start looking perfect. It'll come around.

Patience!

Rehd