Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: carving a foam seat??
By:LeeG
Date: 10/13/2001, 12:43 am
In Response To: carving a foam seat?? (Terry)

big (3") hole saw, handheld will carve out even chunks about 1/8" at a time. 5" 16-32 grit sanding disc, also handheld, put tape on finger for hooking in center hole, drywall sandpaper to finish.

Messages In This Thread

carving a foam seat??
Terry -- 10/12/2001, 7:16 pm
Re: carving a foam seat??
Don Beale -- 10/13/2001, 11:51 am
Re: carving a foam seat?? *Pic*
Pete Rudie -- 10/13/2001, 10:45 am
Re: carving a foam seat??
steve pollack -- 10/13/2001, 9:21 am
Re: carving a foam seat??
LeeG -- 10/13/2001, 12:43 am
Re: carving a foam seat??
Bill Price -- 10/13/2001, 12:23 am
Re: carving a foam seat??
Richard Boyle -- 10/12/2001, 10:17 pm
Sureform
Jim Eisenmenger -- 10/15/2001, 8:34 am
Re: handheld
LeeG -- 10/15/2001, 12:52 pm
Re: carving a foam seat??
Mike Nicholson -- 10/12/2001, 9:09 pm
Re: carving a foam seat??
Dean Trexel -- 10/12/2001, 7:41 pm
Re: carving a foam seat??
Fred Church -- 10/12/2001, 7:49 pm