Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Strip Thickness Tolerances
By:Mark Kanzler
Date: 9/21/1998, 3:29 pm
Date: 9/21/1998, 3:29 pm
In Response To: Re: Strip Thickness Tolerances (Mike Spence)
This may be a problem if the only tallest strips contact the feed rollers. Your router bit method is probably the most cost effective method anyway.
> A possible solution for these machines would be to feed
> as many strips through at one time so as to distribute the roller pressure
Messages In This Thread
- Strip Thickness Tolerances
Lars -- 9/21/1998, 12:27 pm- Re: Strip Thickness Tolerances
Scotty -- 9/21/1998, 9:33 am- Re: Strip Thickness Tolerances
Paul A. Lambert -- 9/21/1998, 7:38 am- Re: Strip Thickness Tolerances
Mark Kanzler -- 9/21/1998, 11:16 am- Re: Strip Thickness Tolerances
Mike Spence -- 9/21/1998, 3:07 pm- Re: Strip Thickness Tolerances
Mark Kanzler -- 9/21/1998, 3:29 pm
- Re: Strip Thickness Tolerances
- Re: Strip Thickness Tolerances
- Re: Strip Thickness Tolerances
Nolan Penney -- 9/21/1998, 7:18 am- Re: Strip Thickness Tolerances
Mark Kanzler -- 9/21/1998, 10:45 am
- Re: Strip Thickness Tolerances
Mike Scarborough -- 9/21/1998, 1:58 am - Re: Strip Thickness Tolerances
- Re: Strip Thickness Tolerances
