Well, I finally have all the deckbeams done for my boat ( all 17 of them! ). Some were laminated together for mast partners, basically a 6inch wide ( fore and aft ) beam, that will later have a 2in hole cut in them for the masts.

The trouble I have is that the curve is not the same on all of them, the amount of 'rebound' from the jig wasn't exacty predictable. So, I now have to fair them out. Since the curve was shallower the peak is not high enough even though the sides are flush with the shear clamp. I thought about using wedge shaped shims. They worked well when I had to shim out the stern, but that's another story.

Thought? thanks in advance.