> I have custom outfitted my boat for the first time. I am now making a few
> modifications which require removing some of the foam which was applied
> with some of the auto store adhesive (one of the reccomended 3M products).
> I pulled the seat back off with considerable effort (it was glued to rear
> bulkhead) and actually pulled off some epoxy and a few chips of outer
> veneer. In other spots I left unsightly clumps of foam. So the good thing
> is I now feel very confident that my foam will hold in place when rolling
> etc., but I would like to know if there is a technique or product which
> makes removal go a bit easier.

> Thanks, Dave

This might not save the foam, but might save your epoxy and wood. You'll have to get a corner or edge of the foam separated (razor blade or other sharp object) first. Then, while pulling gently, you use a small brush to apply a solvent (mineral spirits works on many adhesives) to that area. Keep pulling gently and wetting that seam and,eventually, the foam should come off.

And, as George implied, the natural tendency seems to be to to use too much adhesive for jobs like this.

Good luck, Don