> I have custom outfitted my boat for the first time. I am now making a few
> modifications which require removing some of the foam which was applied
> with some of the auto store adhesive (one of the reccomended 3M products).
> I pulled the seat back off with considerable effort (it was glued to rear
> bulkhead) and actually pulled off some epoxy and a few chips of outer
> veneer. In other spots I left unsightly clumps of foam. So the good thing
> is I now feel very confident that my foam will hold in place when rolling
> etc., but I would like to know if there is a technique or product which
> makes removal go a bit easier.

A thin flexible putty knife will cut through the foam easily. It leaves a thin layer of foam glued to the fiberglass, but a light sanding can remove most of the residue.