Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Is it a strip or S&G deck? *LINK*
In Response To: Other: warped deck or hull (john walker)
I can't advise on strippers but can on S&G. If the warp is really bad that a lot of force has to be applied to get it to mesh with the deck then I'd say use heat to remove the glass, break the joints and reglue. If it can be forced then use the heat methods that the others are suggesting. Recently I had to mesh a S&G deck and hull that had some serious warps between them. I used gentle force and some prying to get them to work. Go through the images to find the ones that show what I did.
Hope this helps.
Robert N Pruden
Messages In This Thread
- Other: warped deck or hull
john walker -- 12/1/2004, 5:18 pm- Re: Other: warped deck or hull
Rob Macks -- 12/2/2004, 7:10 pm- Re: Other: warped deck or hull
Robert N Pruden -- 12/2/2004, 8:23 pm- Re: Other: warped deck or hull
john walker -- 12/3/2004, 11:41 am- heat the clamp a little if you are worried
Robert N Pruden -- 12/3/2004, 4:30 pm
- heat the clamp a little if you are worried
- Re: Other: warped deck or hull
- Re: Other: warped deck or hull *LINK*
john walker -- 12/2/2004, 12:31 pm- Re: Other: BUT.., be careful.. *Pic*
Tom Bastiansen -- 12/3/2004, 10:29 am- Re: Other: BUT.., be careful..
john walker -- 12/3/2004, 12:17 pm
- That's a good method. *Pic*
Jesper Bach -- 12/3/2004, 4:41 am - Re: Other: BUT.., be careful..
- Is it a strip or S&G deck? *LINK*
Robert N Pruden -- 12/2/2004, 10:06 am- Re: Other: warped deck or hull
Ken Blanton -- 12/2/2004, 5:46 am- Re: Other: warped deck or hull *Pic*
Jesper Bach -- 12/2/2004, 1:47 am- Re: Other: warped deck or hull
Barry Shelton -- 12/1/2004, 10:00 pm - Re: Other: warped deck or hull
- Re: Other: warped deck or hull
